Outil de diagnostic téléphone

Vous doutez de votre matériel ? Lancez ces vérifications guidées grâce aux codes de diagnostic intégrés à votre téléphone.

Tests tactiles, d'écran et de capteurs

Il s’agit de contrôles guidés sur votre téléphone, pas de mesures effectuées par le navigateur ni d’un diagnostic de réparation. Leur lecture ne nécessite ni paiement ni téléchargement.

Test tactile

Nettoyez et séchez l’écran, débranchez le chargeur et retirez toute protection abîmée. Dans une application de dessin, tracez des lignes continues au centre et sur les bords. Des interruptions ou marques inattendues peuvent indiquer un problème ; recommencez après un redémarrage. Si un menu propose une grille tactile, suivez ses instructions.

Test d'écran

Affichez des images rouges, vertes, bleues, blanches et noires avec une luminosité modérée. Cherchez pixels morts, décoloration et scintillement. Comparez avec un autre écran : une capture ne révèle pas une panne physique de la dalle. Ne pressez pas l’écran.

Test des capteurs

Vérifiez la rotation automatique dans une application compatible. Pendant un appel normal, couvrez puis découvrez la zone de proximité et observez l’extinction puis l’allumage de l’écran. Étuis et protections peuvent gêner. Utilisez les tests de capteurs uniquement si votre modèle les propose ; ces contrôles ne certifient pas tous les capteurs.

Listes de codes de test par marque

Display & Touchscreen

Verify screen colour uniformity, dead pixels, and touch responsiveness across the whole panel.

*#0*#
1. Dial the code to open the built-in test menu.\n2. Cycle Red, Green, Blue and White screens — look for dead or stuck pixels.\n3. Run the touch test and draw across every edge to confirm digitizer response.

Battery Health

Check current battery voltage, temperature and charging behaviour.

*#*#4636#*#*
1. Dial the code and open Battery information.\n2. Note the current charge, temperature and health status.\n3. Compare voltage under load vs idle to spot a degrading cell.

Network & Signal

Inspect signal strength, cell ID and neighbouring towers.

*3001#12345#* (iOS) / *#*#4636#*#* (Android)
1. Dial the code for your platform.\n2. Read the signal in dBm — closer to 0 is stronger.\n3. Note cell ID and PLMN for troubleshooting weak-signal areas.

Sensors

Test accelerometer, gyroscope, proximity and light sensors.

*#0*#
1. Open the test menu.\n2. Select Sensors and verify each sensor reacts to motion, light, or covering the proximity area.\n3. Fail any sensor that does not update.

Speaker & Vibration

Confirm the earpiece, loudspeaker and vibration motor all fire.

*#*#0842#*#*
1. Run the vibration test — the phone should pulse.\n2. Run the melody / speaker test and listen for distortion.\n3. Place a call to verify the earpiece.

Camera

Trigger front and rear cameras through the diagnostic menu to spot lens or sensor failures.

*#0*#
1. Open the built-in test menu.\n2. Launch front and rear camera tests.\n3. Look for stuck pixels, discolouration, or autofocus failures.

GPS

Verify GPS satellite lock and location fix accuracy.

*#*#1472365#*#*
1. Dial the code and start the GPS test.\n2. Move outdoors and wait up to 60 seconds for a fix.\n3. Confirm satellites in view and accuracy in metres.