Phone Diagnostic Tool

Not sure if your hardware is failing? Run these guided checks using your phone's built-in diagnostic codes.

Touch, screen & sensor checks

These are guided checks on your phone, not browser-run measurements or a repair diagnosis. No payment or download is required to read them.

Touch test

Clean and dry the display, disconnect the charger and remove a damaged protector. In a drawing app, draw continuous lines across the centre and all edges. Gaps or unexpected marks can indicate touch problems; repeat after restarting. If an available built-in menu offers a touch grid, follow its on-screen instructions.

Screen test

View solid red, green, blue, white and black images at moderate brightness. Check for dead pixels, discolouration and flicker. Compare with another display: a screenshot cannot show a physical panel fault. Do not press on the panel.

Sensor test

Check auto-rotation in an app that supports it. During an ordinary call, cover and uncover the proximity area and observe whether the display turns off and back on. Cases or protectors can interfere. Use sensor tests only if offered by your model’s menu; these checks do not certify every sensor.

Test code lists by brand

Display & Touchscreen

Verify screen colour uniformity, dead pixels, and touch responsiveness across the whole panel.

*#0*#
1. Dial the code to open the built-in test menu.\n2. Cycle Red, Green, Blue and White screens — look for dead or stuck pixels.\n3. Run the touch test and draw across every edge to confirm digitizer response.

Battery Health

Check current battery voltage, temperature and charging behaviour.

*#*#4636#*#*
1. Dial the code and open Battery information.\n2. Note the current charge, temperature and health status.\n3. Compare voltage under load vs idle to spot a degrading cell.

Network & Signal

Inspect signal strength, cell ID and neighbouring towers.

*3001#12345#* (iOS) / *#*#4636#*#* (Android)
1. Dial the code for your platform.\n2. Read the signal in dBm — closer to 0 is stronger.\n3. Note cell ID and PLMN for troubleshooting weak-signal areas.

Sensors

Test accelerometer, gyroscope, proximity and light sensors.

*#0*#
1. Open the test menu.\n2. Select Sensors and verify each sensor reacts to motion, light, or covering the proximity area.\n3. Fail any sensor that does not update.

Speaker & Vibration

Confirm the earpiece, loudspeaker and vibration motor all fire.

*#*#0842#*#*
1. Run the vibration test — the phone should pulse.\n2. Run the melody / speaker test and listen for distortion.\n3. Place a call to verify the earpiece.

Camera

Trigger front and rear cameras through the diagnostic menu to spot lens or sensor failures.

*#0*#
1. Open the built-in test menu.\n2. Launch front and rear camera tests.\n3. Look for stuck pixels, discolouration, or autofocus failures.

GPS

Verify GPS satellite lock and location fix accuracy.

*#*#1472365#*#*
1. Dial the code and start the GPS test.\n2. Move outdoors and wait up to 60 seconds for a fix.\n3. Confirm satellites in view and accuracy in metres.